81900518 Rev. A
©2020 JMA Wireless. All rights reserved. This document contains proprietary information. All products, company names, brands, an
d logos are trademarks™ or
registered® trademarks of their respective holders. All specifications are subject to change without notice. Revised: February 13, 2020
+1 315.431.7100 [email protected]
Installation Guide
SV02UTS136-PT
Instructions for Under-the-Seat Antenna
10
11
Connecting external jumpers to pigtails (cont)
Using a calibrated torque wrench on the male jumper 2.2-5.0
connector, torque the connects to 26.55 lbf·in (3 N·m or 2.21 lbf·ft).
Push the WPS boot onto the port seal, making sure the ribs of the
port seal are fully covered by the WPS boot.
Cable pass-through
Install any pass-through cables one at a time, to avoid potential damage
to the RF pigtail cables. When the coax emerges, pull gently by hand
until it’s completely through.
