JLL Ventus Pro Air Power, Инструкция по эксплуатации

Страница: 11 / 22

11
VENTUS PRO ASSEMBLY
The rower has been assembled and tested at the factory, so you shouldn’t have any
problems putting all the parts together. Components are designed to fit together, and
only basic tools are required for the assembly process. Inside the box you will find a Tools
Pack (Hex Allen Key, Spanner, Washers and Bolts). See previous page.
To assemble your JLL Ventus PRO please follow these easy steps:
STEP 1
Attach the center stand to the underside of the
main base using four Allen head bolts found in the
frame.
STEP 2
Attach the rear stabiliser to the base using four
screws found in the frame.
STEP 3
Attach the front stabiliser to the slideway using the
six Allen head bolts found in the stabiliser. Two of
these bolts will also be secured with a small hex nut.
Make sure when attached the slideway the plastic
cap on the stabiliser is lifted.
STEP 4
Next, remove the black plastic stopper from the
opposite end of the slideway using both the large
Allen key and multi-tool.
Remove the large flat knob and two silver hex nuts
from either side.