JLG X20JPLUS, Инструкция оператора по безопасности, техническому обслуживанию и ремонту

Страница: 109 / 206

USING THE MACHINE
107
MUX20JP021602
Boom Lift Models X20JPLUS
PROCEDURE FOR ROUTINE MOVEMENT OF THE AERIAL PART
a Before moving the aerial part, make sure that:
– All instructions provided in this chapter have been complied with.
– There are no obstacles in the work area.
– All the conditions necessary for working at a height are met.
– The machine is stabilised and levelled: icon 5 shown on the display.
– The weight in the basket is below the maximum allowed.
– The remote control is positioned in the basket.
– The basket access ladder has been folded into the raised position so as not
to risk contact during movement of the aerial part.
b The aerial part can ONLY be moved from the control position in the basket.
c Select the motor speed as required and check the selection on the display.
d Use joysticks on the remote control to move the aerial part as described in the
paragraph regarding the description of the controls ʺ Joystick (p. 59) ʺ .
e If the movements are selected when one of the conditions listed above is not
satisfied, an error message will be shown on the display indicating what condi ‐
tions are OK and what are not satisfied (FAIL). If the missing condition is stabili ‐
sation, the message will also indicate what stabiliser is not resting on the ground.
ST1: if OK stabiliser 1 is resting on the
ground
ST2:
if OK stabiliser 2 is resting on the
ground
ST3:
if OK stabiliser 3 is resting on the
ground
ST4:
if OK stabiliser 4 is resting on the
ground
INLC:
if OK the machine is under the
maximum inclination limit
LOAD: if OK, the load is less than the
maximum working load allowed
BASKET: if OK the remote control is in
place in the basket
PEDAL: if OK the foot switch is pushed
Fig. 100 Error machine not stabilised