JLG 530LRT, Руководство по обслуживанию и ремонту

Страница: 194 / 262

SECTION 4 - BASIC HYDRAULIC INFORMATION & SCHEMATICS
4-84 3121781
Oscillating Axle Cylinder Bleeding Procedure
1. Start the engine.
2. Raise the arms high enough so that the left axle cyl-
inder bleeder valve can be accessed.
3. Let engine run at idle.
4. Position a suitable container [approximately 0.5 gal
(1.9 l)] over the bleeder valve.
5. Using a 3/8” wrench, slowly open bleeder valve.
6. Keep the container close enough to the bleeder
valve to catch the aerated oil.
7. Open the bleeder valve enough to get a fast stream
of oil.
NOTE: A fast stream of oil will exhaust the air out of the
hoses and cylinder better than a slow stream of oil.
8. Every 3-4 seconds, close the bleeder valve so that a
slower stream of oil is being purged. When only oil
and no air is being purged, close the bleeder valve.
9. A new system can take 10-15 seconds per cylinder to
bleed.
ANYTIME EITHER OF THE HOSES PLUMBING TO THE CYLINDERS ARE
BROKEN INTO, AIR HAS BEEN INTRODUCED INTO THE SYSTEM. THE
CYLINDERS MUST BE BLED.
1. Oscillating Axle Cylinder 2. Bleeder Valve
Figure 4-43. Oscillating Axle Cylinder Bleeding
1
1
1
2