JLG 1532R, Руководство по эксплуатации и безопасности

Страница: 89 / 98

SECTION 5 - GENERAL SPECIFICATIONS AND MAINTENANCE
3121744 – JLG Lift – 5-27
2568 TEMPERATURE CUTOUT ACTIVE - AMBI-
ENT TEMPERATURE TOO LOW If Transport-
Mode = TRUE
PF: Continuous
If Transport-
Mode = FALSE
PF: OFF
2_5 • Drive and Lift Restrictions • The temperature as communicated by the temperature sensor
located on the temperature/tilt sensor is less than or equal to
{PERSONALITIES->TEMP CUTOUT->CUTOUT SET}
• (See Low Temperature Cutout Functionality)
• This DTC shall not be displayed in GroundMode, and no
restrictions shall be implemented.
421 POWER MODULE TOO HOT - PLEASE
WAIT None 4_2 • DriveState = PREVENTED
• LiftUpState = PREVENTED • Heatsink temperature above 203°F (95° C).
• Possible Cause:
•
Controller is operating in an extreme environment.
• Excessive load on vehicle.
• Improper mounting of controller
4235 POWER MODULE TOO HOT - REDUCED
OPERATION None 4_2 • DriveState =CREEP
• LiftUpState = CREEP • Heatsink temperature exceeded 185° F (85° C).
• Effect: Reduced drive and brake torque.
• Possible Cause:
•
Controller is performance-limited at this temperature.
• Controller is operating in an extreme environment.
• Excessive load on vehicle
• Improper mounting of controller.
4236 POWER MODULE TOO COLD - MODULE
SHUTDOWN None 4_2 • DriveState = PREVENTED
• LiftUpState = PREVENTED • Heatsink temperature below -40° F(-40°C).
• Possible Cause:
•
Controller is operating in an extreme environment.
Table 5-13. Diagnostic Trouble Codes (DTC)
DTC Help Message Alarm
Flash
Code
Action Trigger