JLG 1532R, Руководство по эксплуатации и безопасности

Страница: 36 / 98

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-4 – JLG Lift – 3121744
3.6 BATTERY CHARGING
NOTE: Be sure that machine is parked in a well ventilated area
before charging begins.
ONLY PLUG THE CHARGER INTO A PROPERLY INSTALLED AND GROUNDED
OUTLET. DO NOT USE GROUND ADAPTORS OR MODIFY PLUG. DO NOT TOUCH
NON-INSULATED PORTION OF OUTPUT CONNECTOR OR NON-INSULATED
BATTERY TERMINAL.
DO NOT OPERATE CHARGER IF THE AC SUPPLY CORD IS DAMAGED OR IF THE
CHARGER HAS RECEIVED A SHARP BLOW, BEEN DROPPED, OR OTHERWISE
DAMAGED IN ANY WAY.
ALWAYS DISCONNECT THE CHARGER AC SUPPLY BEFORE MAKING OR BREAK-
ING THE (POS/NEG) CONNECTIONS TO THE BATTERY.
DO NOT OPEN OR DISASSEMBLE CHARGER.
1. The battery charger AC input plug is located inside the
frame at the left rear of the machine next to the bat-
tery charger.
See charger specific information in Section 5 starting on
page 5-12.
2. Connect the charger AC input plug to a grounded out-
let using a 3 wire heavy duty extension cord.
(See Table 5-6, “Battery Charger Specifications,” on
page 5-6, for battery charger AC input specifications.).
3. After connecting the charger to an AC outlet at the
start of the charging cycle, check the LED indicators on
the charger for normal operation or if a fault has
occurred.
See LED indicator status of each charger in Section 5,
starting on page 5-12.
4. Current battery charge state can also be seen on the
platform control station panel LEDs, or the MDI indica-
tor (if equipped) on the ground control station, when
machine is powered up.
5. The batteries are fully charged when all three GREEN
LED indicators on the platform control station or MDI
battery charger status panel are illuminated.
(See “MDI-Indicator - (If Equipped)” on page 3-7 for MDI
indicator information.
NOTE: If the charger is left plugged in, the charger will automati-
cally restart a complete charge cycle if the batteries volt-
age drops below a minimum voltage or 30 days has
elapsed.