JLG 1532R, Руководство по эксплуатации и безопасности

Страница: 29 / 98

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
3121744 – JLG Lift – 2-7
2.4 DAILY WALK-AROUND INSPECTION
Begin the “Walk-Around Inspection” at item 1, see Figure 2-1.
Continue checking each item in sequence for the conditions
listed in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”. DO NOT
OPERATE UNTIL ALL MALFUNCTIONS HAVE BEEN CORRECTED.
NOTICE
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE. CHECKING
THIS AREA MAY RESULT IN DISCOVERY OF CONDITIONS WHICH COULD CAUSE
EXTENSIVE MACHINE DAMAGE.
INSPECTION NOTE: On all components, make sure there are no
loose or missing parts, that they are securely fastened, and that
no visible damage, leaks or excessive wear exists in addition to
any other criteria mentioned.
1. Frame/Chassis/Ladder - See Inspection Note . Ensure
that pothole protection (PHP) components on frame
are in place, undamaged, not bent or worn. Side com-
partment doors open and close properly.
2. Ground Controls - Placard secure and legible, control
switches return to neutral position, emergency stop
switch functions properly. Control markings legible.
3. Hydraulic Pump/Motor, Control Valve Installation - No
unsupported wires or hoses; no damaged or broken
wires -
See Inspection Note.
4. Front Wheels, Tires and Drive Motors - Steer linkage,
and Steer Cylinder -
See Inspection Note.
5. Battery Compartment - See Inspection Note .
6. Rear Wheels, Tires and Hydraulic Brake - Wheel nut
properly secured. Refer to “Tire Wear and Damage” on
page 5-15. Inspect wheels for damage and corrosion,
check hydraulic brake hoses for damage or leakage -
See Inspection Note.
7. Manual Descent Control - See Inspection Note.
8. Beacon(s) (if equipped) - See Inspection Note.
9. Scissor Arms, Pivot Pins and Sliding Wear Pads, Lift Cyl-
inder -
See Inspection Note.
10. Platform/Handrail/Gate/Chain Installation - Deck
extension slides in and out and locks in place properly.
Gate closes properly. All fold-down rail pins
(if
equipped) in place and secure - See Inspection Note.
11. Platform Control Console - Ensure that the control
console is firmly secured in the proper location. Plac-
ards secure and legible, control lever and switches
return to neutral, and emergency stop switch function
properly, required manuals in storage box.