Continued on Next Page
SB-HY-VELOSTR/10TW3 INSTR_SKU# 011355
Page 6 • JL Audio, Inc., 2016
S T E P 2 8
Slide two more 3/8” Fender Washers over the 3/8 - 16 x 2-1/2”
Bolt as shown.
S T E P 3 2
Reinstall the plastic divider panel, rear seat back, rear seat
cushion, rear door sill panel, latch cover, cargo sill panel, and
trunk floor panel.
S T E P 2 7
Slide a 3/8” Fender Washer over a 3/8 - 16 x 2-1/2” Bolt. Slide
the assembly from the back of the brace through the hole
made in
Step 19
. Slide a 3/8” Flat Washer and a 3/8” Lock
Washer over the 3/8 - 16 x 2-1/4” Bolt from the front of the
brace, then thread on a pair of 3/8 - 16 Hex Nuts.
Reference
Step 24
for clarity.
S T E P 3 1
Reinstall the passenger side panel into the vehicle, allowing
the two 3/8 - 16 x 2-1/4” Bolts to pass through the holes
made in the previous step.
S T E P 2 6
Pictured is the installed hardware from the outer fender well.
Lower the vehicle back to the ground.
S T E P 3 0
Using a Phillips head screwdriver, remove the subwoofer
from the Stealthbox®. Place the enclosure over the
passenger side panel, aligning it with the top of the panel.
Mark the locations of the holes in the enclosure onto the
panel. Remove the enclosure and drill 3/8” holes on the
marks.
S T E P 2 5
Slide a 3/8” Flat Washer and a 3/8” Fender Washer over a
3/8 - 16 x 2-1/2” Bolt. Slide the assembly from the outside of
the vehicle through the hole made in
Step 23
. Slide a 3/8”
Fender Washer and a 3/8” Lock Washer over the 3/8 - 16 x
2-1/2” Bolt from the inside of the vehicle, then thread on a
3/8 - 16 Hex Nut.
Reference
Step 24
for clarity.
S T E P 2 9
Pictured is all the hardware after installation.
