Continued on Next Page
SB-HY-VELOSTR/10TW3 INSTR_SKU# 011355
Page 5 • JL Audio, Inc., 2016
S T E P 2 0
Measure and mark up 4-1/2” from the floor at the center of
the indented section of the wheel well as shown.
S T E P 2 4
Reference this illustration for clarity in
Steps 25-29
.
S T E P 1 9
Drill a 3/8” hole on the mark made in the previous step.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
S T E P 2 3
Enlarge the hole made in the previous step to 3/8”.
S T E P 1 8
Measure and mark down 7” from top of the factory hole as
shown.
S T E P 2 2
Drill a 1/8” pilot hole on the mark made in
Step 20
.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
S T E P 1 7
Pictured is the back of the vehicle with the passenger side
panel removed.
S T E P 2 1
Jack up the rear passenger side of the vehicle.
