JL Audio FATHOM IWS-SYS-108, Руководство по установке

Страница: 13 / 20

Page 13 | Fathom IWS
L-Bracket Installation
Remove the enclosure from the
wall cavity and place on a supported
surface/table. Each L-Bracket includes
two slotted openings for installation
over two rows of predrilled pilot holes
located at each end of the enclosure’s
top and bottom. The slotted openings
allow adjustment of the L-Brackets
when mounting the enclosure within
the wall cavity.
(Figure 8)
Place an L-Bracket along one of the
marked lines on the enclosure’s top,
with its slotted openings positioned
over the pilot holes. Select two, non-
adjacent pilot holes within each slotted
opening (one to two holes apart) and
fully install two #8 x 1-inch pan head
screws. Then, partially back out each
screw, leaving just one to two threads
exposed beneath each screw head.
The L-Bracket should remain loose,
allowing it to slide for adjustment
during installation. Repeat this
procedure with the other marked line
on the enclosure’s top.
(Figure 9 & 10)
Noting the L-Bracket screw
locations on the enclosure’s top,
attach the two remaining L-Brackets
to the enclosure’s bottom in the
same manner. Each screw should
be installed in the same pilot hole
locations as on the enclosure’s top.
(Figure 11)
Figure 9
Figure 10
Figure 8
Figure 11