Jin Ming Yuan LED300W, Инструкция по эксплуатации

Страница: 18 / 19

resistance;

6. light fixtures can not start

The reason is that the power supply line is bad.

Check whether the fuse on the power input
socket is fusible and replace the insurance.

Lamps cause poor contact in long distance
transportation due to vibration.

Check the input power supply, computer board
and other plug - in devices
。
1. use of attention

Check whether the local power supply meets the rated voltage requirements of the product, and the leakage
protector and overcurrent protector meet the load requirements.

Please do not use insulated conductor which has been damaged.

The lamps and lanterns use strong wind refrigeration, easy to accumulate dust, it must be cleaned once a
month, especially the heat dissipation tuyere, otherwise the dust will be blocked, resulting in bad heat
dissipation and abnormal luminaires.

When fixing the luminaire, the fastening screws must be fastened and equipped with safety cables and
checked regularly.

In the installation and positioning of the lamps and lanterns, any point on the surface of the lamp and any
easy to burn explosive, keep the minimum distance of 10 meters and the distance of 2.5 meters from the
illuminant, please do not install the lamp directly on the surface of the combustible material.

The continuous working time of lamps and lanterns should not be more than 10 hours, the interval of
continuous starting lamps should not be less than 10 minutes, otherwise it will not be triggered normally
because of the protection of the light bulb.

The closing time of using on-off valve should not exceed 5 minutes. If you need to shut down the light for a
long time, you should use the console (light control channel) to turn off the light bulb.

In order to ensure that many lamps and lanterns comply with the effect of the scene better, the lamps should
not always be in the unfinished scene, that is, start the next scene action, it is best not more than 3 minutes
to ensure that multiple lamps can run synchronously.

During the process of use, if lamps and lanterns are abnormal, they should stop using lamps in time to
prevent other faults.