ELECTRONIC SETUP
NOTE: Make sure the Clutch is loose enough to allow the Sprocket to “free wheel” on its shaft
.
Clutch Screw
Spring Washer
Drive Sprocket
Idler Sprocket
Drive Shaft Taper
1.
Mount the Dutch Control Box to the weight bar and connect the Dutch electrical Cables
Except the Servo
.
Make sure the unit is off and plug in the motor. Do not connect any of the Camera cables or focus/iris
cables at this time.
2.
Rotate the Control Knob to the center position and turn the controller on.
3.
Go forward to the Head and tighten the Clutch. By turning the Control Knob Dutch the head slightly and
determine the Direction. Use the Direction Switch if the head movement is not to your preference. Normally
the Knob would be set mimic rocking the Camera from side to side.
RIGHT
RIGHT
Dutch Control Box
