8
Installation
1. Find a flat area and make sure that the surface you have selected to set
up the boat is completely free of stones, sticks, sharp objects or other
foreign debris.
2. Carefully unfold the boat, spreading out the tubes and floor to make
them as smooth as possible. NOTE: For ease of install, it is preferable to
set up the boat on a warm and sunny day. If time permits, expose the
unrolled boat to direct sunlight for 1 hour or more, so that the boat
material will be more flexible during installation.
CAUTION: DO NOT DRAG THE BOAT, AS IT MAY TEAR THE
BOAT OR CAUSE OTHER DAMAGE. We will not be held
responsible for damage caused to the boat due to mishandling or failure
to follow these instructions.
3. Insert 4 wooden boards into the sleeves located on the boat floor, and
position the boards into the middle of the sleeves. See below A, B
diagrams:
(A) (B)
4. Wooden bench seat installation:
Insert the plastic (or wooden) rods into the seat retaining tubes (C). Side
the seat into position by inserting the retaining tubes into the grooves
located at each end of bench seat. Insert into both ends of the seat at the
same time (D) and (E). Position the seat to be in the middle of the
retaining tubes.
