Connect the battery to the charger and wait the indication light
BATTERY LOADED
(charging time may vary depending on battery capacity and the source used). Read in display a
quantity from Amps than a battery Accumulated during o process from load.
Verify the value obtained is close to the amount of amperes specified by the battery
manufacturer (e.g. If the battery charged is 60A, the obtained value should be close to 60A). The
lower, in relation to the value indicated by the manufacturer, the worse the battery status. If a
battery bank is used in parallel, add the currents of the seat batteries.
(Note: When the meter reaches 9 9 9 it must be reset to continue reading the
accumulated charge on the battery).
VOLTAGE READING
The X-LINE Source display allows you to view the output voltage (in Volts) that is being
applied at that time to the system. To access this voltage value, press the
SELECTOR READING
switch until the
VOLTAGE INDICATOR LED
lights up.
CURRENT READING
The X-LINE Source display allows you to view the output current (in amperes) that is being
applied at that time to the system. To access this current value, press the
SELECTOR READING
switch until the
CURRENT INDICATOR LED
lights up.
9
CONTROL PANEL
VOLTAGE
BATTERY
AUTO
ICS
SLOW
CHARGE
OUTPUT
VOLTAGE
CHARGED
BATTERY
2.ABSORPTION
3.EQUALIZATION
MODE
SELECTOR
READING
SELECTOR
VOLTAGE
AMPERAGE
1.ELEVATION
SLOW CHARGE
PHASES
BATTERY CHECK-UP
SELECTOR
super-x
METER
CCA - Ri m
1
PAINEL DE CONTROLE
TENSÃO
BATERIA
AUTO
SCI
CARGA
LENTA
TENSÃO
SAÍDA
BATERIA
CARREGADA
2. ABSORÇÃO
3. EQUALIZAÇÃO
SELETOR
MODO
SELETOR
LEITURA
TENSÃO
CORRENTE
1. ELEVAÇÃO
CARGA LENTA
CHECK-UP DA BATERIA
SELETOR
MEDIDOR
CCA - Ri m
1
X-LINE SOURCES AND CHARGERS - INSTRUCTION MANUAL
