JETWAY HPC-185SC-HD1900B Series, Руководство пользователя

Страница: 30 / 44

26
The optional settings are: [Sec.]; [Min.].
WatchDog Wake-up Timer
Support WDT Wake-up.
The optional settings: [Disabled]; [Enabled]. When set as [Enabled], the following
sub-items shall appear:
WatchDog Wake-up Timer Value
User can set a value in the range of [10] to [4095] seconds when
‘
WatchDog
Wake-up Timer Unit ’ set as [Sec.], or in the range of [1] to [4095] minutes when
‘ WatchDog Wake-up Timer Unit ’ set as [Min.].
WatchDog Wake-up Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select AT or ATX Mode on MB jumper at first (refer to
Page
14 , AT_MODE jumper for ATX Mode / AT Mode Select).

Serial Port Console Redirection
COM1
Console Redirection
The optional settings: [Disabled]; [Enabled]. When set as [Enabled], the following
sub-items shall appear:

Console Redirection Settings
The settings specify how the host computer and the remote computer (which the
user is using) will exchange data. Both computers should have the same or
compatible settings.
Press [Enter] to make settings for the following items:
Terminal Type
The optional settings: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
Emulation: VT100: ASCII char set; VT100+: Extends VT100 to support color,
function keys, etc.; VT-UTF8: Uses UTF8 encoding to map Unicode chars onto
1 or more bytes; ANSI: Extended ASCII char set.
Bits per second
Use this item to select serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings: [9600]; [19200]; [38400]; [57600]; [115200].
Data Bits
The optional settings: [7]; [8].
Parity
A parity bit can be sent with the data bits to detect some transmission errors.
The optional settings: [None]; [Even]; [Odd]; [Mark]; [Space].
Even: parity bit is 0 if the num of 1’s in the data bits is odd; Mark: parity bit is
always 1; Space: Parity bit is always 0; Mark and Space Parity do not allow for
error detection.
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard settings is 1 stop bit. Communication with slow
devices may require more than 1 stop bit.
The optional settings: [1]; [2].