9
CNR
CNR Slot
Communication Network Riser slot
Support Audio, Modem only
Chapter 2
Hardware installation
2-1 Hardware installation Steps
Before using your computer, you had better complete the following steps:
1.
Check motherboard setting
2.
Install CPU
3.
Install Memory
4.
Install Expansion cards
5.
Connect Ribbon cables, Panel wires, and power supply
6.
Setup BIOS
7.
Install software driver & utility
2-2 Checking Motherboard’s Jumper Setting
1.
CPU Front Side Bus Frequency Setting (2-pin): S1
The motherboard’s CPU Host clock adjusted through jumper S1.
CPU Front Side Bus Frequency
S1
1
2
ON : 133MHz/266MHz
OFF : 100MHz/200MHz
(Default)
S1
1
2
∗
This motherboard also provides CPU Front Side Bus Frequency setting by
Software, please refer
page 40
.
2.
Keyboard Power On Function Setting (3-pin): JP1
This allows you to disable the keyboard power on function. Set the jumper to
enabled or disabled if you wish to use your keyboard (by pressing < >) to power
on your computer. This feature requires an ATX power supply that can supply at
least 300mA on the +5VSB lead. The default is set to disable.
