Jetter JetMove 225-480, Руководство пользователя

Страница: 80 / 126

JetWeb
80 Jetter AG
F 05 Current overload Output current was
greater than 2.5 x
rated current. – Immediate
controller
disable
– Check motor cable for
short circuit between
lines or lines to earth
– Check the current
controller parameters. If
necessary, correct the
parameters
– Acknowledge failure
F 06 Ballast resistor
overload The ballast resistor
has been
overloaded. – Immediate
controller
disable
– Let the amplifier cool
down
– When the motor has
cooled down,
acknowledge failure
– Reduce regeneration
power
F 07 Amplifier
overtemperature The amplifier has
reached the
maximum
temperature. – Immediate
controller
disable
– Let the amplifier cool
down
– When the motor has
cooled down,
acknowledge failure
– Reduce power of the
motion system
F 08 Motor
overtemperature The motor has
reached the
maximum
temperature. Also
refer to "Built-in
thermal sensor",
page 41 – Immediate
controller
disable
– Let the motor cool down
– When the motor has
cooled down,
acknowledge failure
– Reduce the average
load of the motor
F 09 Encoder failure Encoder breakage
or initialization
error – Immediate
controller
disable
– For extended
diagnostics purposes
use Motion Setup
– Check the encoder line
and all plug-in
connections
– Acknowledge failure
F 10 Overspeed The actual shaft
speed has
exceeded a value
of 1.25 x maximum
speed – Immediate
controller
disable
– Check motor and
encoder connections
– Control the speed
parameters. Change
parameters if necessary
– Acknowledge failure
F 11 Current
overrange A current
temporarily too
high has been
detected. – Immediate
controller
disable
– Reduce Kp of the
current controller by 10
to 20 %
– Acknowledge failure
Fault Message Table JetMove 225-480
Fault
Number Type of Error Description Error
Response Rectification