Jetter JetMove 225-480, Руководство пользователя

Страница: 77 / 126

JetMove 225-480
Jetter AG 77
8 Status Monitoring
The output stage LEDs indicate the operating status of the digital servo amplifier.
JetMove 225-480 - LEDs
LED Color Meaning
5 V Green Logic voltage is ok
L1 Yellow Axis is standing still (speed = 0)
L2 Yellow A voltage of 24 V is applied to the input of
the positive limit switch (LIMIT+).
L3 Yellow A voltage of 24 V is applied to the input of
the negative limit switch (LIMIT-).
Note!
The 7-segment display of the output stage indicates the operating and fault
conditions of the digital servo amplifier. The various display modes are set by the
Motion Setup. Mode 0 (default) is used for normal operation and mode 1 for
commissioning.
JetMove 225-480 - 7-Segment Display
Mode 0: Normal Operation
Color Status Meaning
0 NOT READY TO BE
SWITCHED ON Initialization of amplifier functions
1 SWITCH-ON INHIBIT Initialization completed. Safe state
achieved after initialization and
acknowledgement of errors.
The drive controller can be switched
on.
2 READY TO BE SWITCHED
ON Drive controller has been disabled by
software command.
The drive controller can be switched
on.
3 SWITCHED ON DC link monitoring is activated.
4 OPERATION_ENABLED The drive controller is enabled.
7 QUICK STOP ACTIVATED A quick stop has been activated.
The drive was decelerated to n = 0
and then locked.