17
Removing and Replacing Ash Pan
Remove the ash pan by sliding it out from under the grid.
Fit the ash pan by sliding in under the cast bottom grid. Ensure it is fitted the correct way around with the handle
towards the front as shown below.
Bottom Grate Removal and Replacement
The bottom grate can be removed by lifting up at the back edge and lifting out.
The grate may need tilting sideways to clear the stove opening when removing.
To refit, reverse the procedure by inserting the front edge in first and gently lower the back edge.
Internal Board Removal and Replacement (Rear and Sides)
The internal boards need to be taken out in the following sequence: -
IMPORTANT
First remove the Ash Pan then the Bottom Grate followed by the Rear boards and then the Side
boards.
Although the boards are durable care should be taken not to break them during handling.
The position of the boards must be noted so that they can be replaced back in the same positions and order.
Note also that some of the boards can only be fitted one way around or are handed.
Rear Board Removal and Replacement
Remove the rear vertical board by gently pulling the top edge out first, then slide forward.
Replacement is the reverse procedure.
The rear board will need to be tilted/twisted sideways to clear the stove opening in a similar manner to the bottom
grate.
