14
Open the door fully and carefully support the door, at the same time pull down the spring-loaded pin at the top
of the door and lift the door up and outwards away from the lower hinge attachments on the firebox. Set aside
in a safe place for refitting later.
Releasing the door pin
Take care not to damage the door seal.
Place the door on a soft surface in a safe position to protect the glass, paint and inner seal.
Particular attention should be given so that the painted edges do not become damaged.
Refit the door using the reverse process.
Lower door pin on stove body Upper door pin attached to door
Air Control Stop (Low Rate Stop)
Once the door has been removed the low rate stop will be visible. This stop prevents the air control lever being
slid to the fully closed position. This will allow the fire to be turned down to a minimum setting without being fully
closed.
If the fire is installed into a smoke controlled area then the low rate stop
MUST
be left fitted in position. If the fire
is not installed in a smoke controlled area then the stop may be removed.
Log Retainer Removal and Replacement
The log retainer can be detached and removed at the front of the fire box by sliding up, disengaging the tags
from the slots at each side of the inner firebox at the front. To refit, slide down and locate the tags into the slots
at each side of the inner firebox at the front. The retainer should be fitted the correct way around as shown in
the photo.
