Instructions manual: MULi6s Module
5.
Configuration using a DC / DS transmitter:
MULi6s Module can be configured via the DC / DS transmitter via the Connected Devices menu.
In order to configure MULi6s via the transmitter, it is necessary to observe:
•
Firmware version of Duplex 3.12 and later (with Output mode setting -> EX bus).
•
Receiver connected to MULi6s Module with EX Bus.
•
Transmitter firmware version 2.02 and later + device profile (MULi6M.bin) recorded in the
"Devices" directory on the transmitter SD card.
•
If everything is properly plugged in, or configured, the MULi6s Module entry appears in the
Connected Devices menu. Entering this item will go to the configuration menu.
•
Reset to factory defaults
- to retrieve the default MULi6s Module setting.
5.1.
Telemetry
•
Total voltage
- shows the current total battery voltage and the number of all connected cells
•
Number of cells
- shows the current number of connected cells
•
Number of modules
- displays the current number of connected modules
•
The weakest link
- displays the weakest link for the entire flight - its voltage and cell number
•
Largest difference
- shows the current voltage difference between the weakest and the strongest
cell. In addition to the voltage, it also shows the numbers of the cells between which this
difference is measured. The first number corresponds to the strongest cell.
•
Telemetry of all cells
- displays all connected cells and their current voltage difference between
the weakest and the strongest cells.
9
