JETI model Duplex DS-16, Руководство пользователя

Страница: 54 / 164

computer radio control system
EN
You should mechanically adjust all of your servo arms and servo
linkages to be as close to neutral or center as possible so that you
will need as little subtrim as possible. Using large amounts of
subtrim can limit the overall throw of your servo.
Note:
a. Use the „F2(Add)“ button to create a
new mixer. Select „Engine“ in the „From“
item. Then select „Sound M“ (the name of
the sound function) in the „To“ item. The
item
„Master Value“ represents the
amount of mixing from the input function
Once your transmitter has been bound with a receiver and has been
connected to its power supply, the last step consists of tuning the
servo output functions,
see chapter 7.3.4: Setup of receiver
outputs.
To complete this model we just need to configure a free mixer from
the throttle function to the motor sound module. In this example we
will set a switch to enable/disable the mixer so that when the switch
is
„on“, the motor sound module is controlled with the throttle
(motor speed). Go to the „Fine tuning -> Free mixers“ menu.
3. 3.
b. To assign a switch for the activation and
deactivation of the free mixer, press the
„F4(Edit)“ button. Select and edit the
„Switch“ item to assign a switch/stick to
enable/disable the mixer.
to the output function for this mixer. With the „F5(Next)“ button you
will create the mixer and the display will change to show the
overview of your programmed free mixers.
7.3.4 setup of Receiver Outputs
Go to the „Model->Servo Setup“ menu. Use the „F2“ and „F3“
buttons to brows through the receiver outputs (channels).
You can scrol through the following servo adjustment items for each
channel:
„Servo reversing“ – reverses the servo throw direction.
Move the stick for your selected channel and observe the direction
of the servo movement. If the servo moves in the opposite of your
desired direction, change the direction by editing the „Reverse“ item
for that particular servo. Continue with each channel until all of the
servos travel in the required directions.
„Center (Subtrim)“ - adjusts the center position of each servo’s
output.
With your sticks in their neutral positions, scroll through each servo’s
page and use the „Center (Subtrim)“ item to correctly set all of your
servo‘s center or neutral positions.
53