JETI model Duplex DC-16, Руководство пользователя

Страница: 197 / 222

computer radio control system
EN
9.5.2 Servo & Range Test
This menu allows you to perform a range test and servo tests.
During the servo test it is possible to send the test output to all of the
channels which are active in the current model setup. The servo
speed item allows you to adjust the travel time for the servos during
the servo test. During the test, the servos will only be driven to their
programmed maximum throws. You can select which servos will be
included in the test.
1. Servo speed
This menu item allows you to adjust the servo travel speed for the
servo test.
The time shown is the time that it will take for the servo to move from
one travel extreme to the other.
Note: A servo will only move to it’s programmed maximum throw.
2. Servo Number
Use the “3D Control” to select which servos will be included (check
mark) or not included (X) in the servo test.
3. Starting the Servo Test
Press the “F3 (Start)” button to start the test for your selected servo
outputs.
Once started, the servo test will continue to run even if you exit the
menu.
You must stop the servo test before you can change any of the test
settings (speed, output channel).
4. 4.
6. Distance units
This menu item allows you to select the distance units for your
telemetry display. All telemetry data is automatically converted to
your selected units for display.
7. Temperature units
This menu item allow you to select whether your temperature data is
displayed in Farenheit or Celcius.
8. French Tx Mode
Activate this menu item if your DC/DS-16 is being used in France.
9. Disable Startup Question
This menu item disables the question/confirmation during startup.
(see Chapter 6)
10. Reverse Menu navigation
This menu item allows you to reverse the direction that the „3D
control“ scrolls through the menus.
1
2
3 4
5
6
79