JETI model Duplex DC-16, Руководство пользователя

Страница: 151 / 222

computer radio control system
EN
3. 3.
8.4. Range Test
The range test will verify that the transmitter and receiver are
functioning properly.
Before the first flight of each flying session or if have any doubts
about the transmitter or receiver function you should always check
the range. During the range test the transmitter’s output power is
decreased to 10%.
When performing a range test, both the model and the transmitter
should be at a minimum height of 80 cm (31.5“) above the ground. A
correctly functioning transmitter and receiver in range test mode
should safely control a model to a minimum distance of 50m (164‘).
If not, check your model’s antenna installation first. If the test is still
not successful don´t fly the equipment and contact your retail shop
or one of the Jeti authorized service centers.
8.5. Fail safe
All Duplex 2,4GHz system receivers are equipped with „fail safe“, a
function which reacts to control signal transmission interruptions.
When your receiver for any reason does not receive transmitter
information it changes, after a pre-set time period, to one of the
following modes.
„Repeat“ – This mode holds the last valid control throw signal ( this is
the default mode for all receivers)
„Out off“ – There is no output signal provided by the receiver, i. e.
servos do not keep their positions
„Failsafe“ – receiver outputs change to preset positions
Each receiver channel can be configured to one of the modes
described above. We recommend that you setup „fail safe“ positions
for every output which enables your model to stay in a stable
condition. For instance, the elevator and rudder in neutral positions,
electric motor switched-off, gas engine idling, spoilers extended.
Configuration Method of the receiver failsafe function.
1. Bind receiver with transmitter. See chapter: 8.4 Binding . Leave
receiver and transmitter in switched-on condition.
2. In the transmitter, go to the menu „System->Jetibox“ and
proceed according to picture. Use the F1-F4 function buttons to
move within the menu.
3. In the „Set Output Pin“ menu select the receiver output which
you want to configure (use the left/right buttons) and proceed (by
using the down-button).
4. In the „Signak Fault Yn“ menu where n denotes the channel
number which has to be configured, use the right-button to edit the
output function showing a signal failure (set-up „fail safe“). You have
now activated the
„fail safe“ function on receiver channel output n.
5. The „fail safe“ is adjusted by pressing the down-button and
changing to the „fail safe“ menu. With the left/right buttons edit the
„fail safe“ value in a range of 0,8ms to 2,2 ms. Adjust all of the
connected receiver outputs by repeating steps 3-5 .
The last parameter to be set up is the elapsed time after signal failure
when the
„fail safe“ or other actions after signal failure will be
initiated. In the „SignalFault Delay“ menu you can define the length
of time after a signal fault occurrs in which the preset throws are
applied. The values in this menu are changed by pressing the
left/right.buttons.
33