Jetfire E3, Руководство по эксплуатации и техническому обслуживанию

Страница: 6 / 16

6
1. GENERAL ADVICE
The heater must be installed, set up and used in accordance with the applicable regulations
and relating to the use of such equipment. Minimum distance from surrounding walls and/or
ceiling: 2m.
2. ELECTRICAL CONNECTION
•
The voltage, hertz rating and number of phases on the data plate
must correspond to that of the electrical mains outlet that the unit is
being connected to.
•
Only connect the unit to electrical installations made by certified
electricians and in keeping with local electrical regulations and
requirements.
•
Its recommended that the electrical supply to this unit should include either a residual
current device that will interrupt the supply if the leakage current to earth exceeds
30mA for 30 ms or a device that will prove the earth circuit.
•
This Class 1 Appliance must only be connected to an earthed power supply fitted with an
appropriately sized fuse.
•
The heater may be connected to a room thermostat by connecting to the thermostat plug
(10). Other accessories such as a timer may also be connected.
3. POWER CORD
•
Make sure before every use that the power cord assembly is
not damaged or cut. If it is DO NOT connect the unit, have it
replaced by an electrician or authorized service technician.
(Type Y attachment)
•
DO NOT pull on the power cord in order to unplug the unit, remove the plug from the
power outlet.
4.
EXTENSION CORD
•
If using an extension cord, make sure it is a maximum length of 10 meters
and sized according to cross section requirements as shown to the right.
•
Inadequate extension cords can be dangerous. If an extension cord is used,
it must be suitable for outdoor use and the connection must be kept dry and
off ground.
•
Make sure the extension cord is fully unrolled, kept dry, away from
traffic, sharp edges and heat to avoid damage or cuts.
•
If using an extension cord, make sure it is not connected to mains voltage when
connecting / disconnecting to the unit's power cord.
5. TRIP HAZARD
•
Loose extension cords and power cables provide a potential trip hazard,
especially when they cross pathways.
•
Take safety measures like placing traffic cones along the cord or tape the cord
to the floor with duct tape.
6. FIRE PREVENTION AND HOT SURFACE CAUTION
•
Use only in areas free from flammable materials (flammable vapors, high
dust concentrations etc.)
•
Keep combustible materials a safe distance from this unit (minimum 3m)
•
An external guard should be place 1m away from the heater outlet to
prevent the approach of combustible material.