Jetfire E3, Руководство по эксплуатации и техническому обслуживанию

Страница: 5 / 16

5
GENERAL
•
This heater must only be operated by authorized persons.
•
THIS HEATER IS APPROVED FOR INDUSTRIAL USE ONLY.
•
NOT FOR DOMESTIC USE. Space heating only.
•
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE
WHILST IN OPERATION
•
DO NOT USE OR STORE FLAMMABLE MATERIALS IN OR NEAR THIS
APPLIANCE
•
DO NOT MODIFY THIS APPLIANCE
•
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE
•
USE IN A WELL-VENTILATED SPACE.
•
Do not operate the heater if it is damaged.
•
This heater must be positioned and operated on flat stable ground, not exposed to the
elements (rain, hail etc.) and must be operated in an upright position.
•
Never leave the heater unattended while operating.
•
Make sure you have read and understood the whole instruction manual before
installing, operating or carrying out any maintenance on the unit.
•
Warnings and data plates on the unit provide important directions and information on the
safe use of the unit.
•
In addition to these operating and safety instructions, all accident prevention
regulations as well as any standards relating to the installation and operation of
heaters applicable in your country must be strictly followed.
•
This unit is not intended for use by children. Children must always be supervised when in
the vicinity and ensure that they DO NOT play with the unit. Further, it is not intended for
use by persons with reduced physical, sensory or mental capabilities, or lack of experience
or knowledge.
•
The heater is not to be installed in an area where there is a risk of fire or explosions;
•
Never operate this heater in basements or below ground level because of gas stagnation.
•
Do not use the heater on floors made with flammable materials.
•
Do not store flammable materials in the vicinity of the heater (minimum distance: 3m);
•
Ensure no overheating of walls, or ceilings made of flammable materials,
•
Ensure all precautions have been taken to prevent fires;
•
Ensure the premises in which the heater is installed are sufficiently ventilated for the burner
requirements; in particular, limits regarding air quality in the room to be heated must conform
to applicable laws;
•
Ensure nothing is obstructing the aspiration and expulsion of air; movement of air may be
obstructed in various ways including placing covers or other objects on the heater or
positioning the heater too near a wall or other large object;
•
Never direct the hot air flow from the heater towards the gas cylinder
•
Ensure the heater is regularly monitored during operation and checked before being
started;
•
Ensure at the beginning of each use, a check is made that the fan moves freely before
plugging the heater into the electrical power supply;
•
Ensure at the end of each use, the mains switch is disengaged and supply power cord
removed, main gas stopcock is closed and gas tube disengaged and sealed.
IMPORTANT SAFETY INSTRUCTIONS AND
PRECAUTIONS