Jet MBS-1018-1, Руководство по эксплуатации

Страница: 8 / 32

8
Read and understand all
assembly instructions before attempting
assembly. Failure to comply may cause serious
injury.
5.0 Setup and assembly
Disconnect band saw from
power during setup.
5.1 Shipping contents
1 Band saw
1
Tool box containing:
4 Leveling pads
4 Hex cap bolts, 1/2 x 2 in.
4 Hex nuts, 1/2 in.
1 Cross point screwdriver
1 Hex wrench set (metric)
1 Open end wrench set (metric)
5.2 Unpacking and cleanup
1. Finish uncrating saw and inspect for damage.
Should any have occurred, contact your local
distributor.
2. Remove all bolts attaching machine to shipping
pallet.
3. Leave packing material between vise clamps
and saw head intact until band saw has been
lifted to its final position.
4. Clean all rust protected surfaces with a cleaner-
degreaser or kerosene to remove protective
coating. Do not use gasoline, paint thinner,
mineral spirits, etc. These may damage painted
surfaces.
5. Lubricate all slideways with SAE 10W oil.
6. Compare contents of shipping carton with the
contents list in this manual. Report shortages, if
any, to your distributor.
5.3 Installation
1. For best performance, the band saw should be
located on a solid and level foundation. Allow
room for bow swiveling, servicing and for
moving large stock around the machine.
2. Use lifting straps that are isolated from the band
saw’s finished surfaces and knobs, to move
machine to desired location. See Figure 5-1 for
strap placement. Do not strap bow or vise
assembly.
3. Install four leveling bolts with hex nuts through
the base flanges, as shown in sect. 12.2.1 ,
index # 280 and 283.
4. Place a level on the table surface and check
side-to-side and front-to-back.
5. Adjust leveling screws until machine is level in
both directions and tighten nuts against the
base flanges.
6. Remove braces holding control box, and mount
control box directly to bow, using the existing
screws and washers.
7. Install material stop into front hole in table, as
shown in Figure 7-9.
8. Fill coolant reservoir with 15L (4 gal.) of
appropriate coolant, by pouring it through the
filter screen atop the pan.
Figure 5-1
6.0 Electrical connections
Electrical connections must be
made by a qualified electrician in compliance
with all relevant codes. This machine must be
properly grounded to help prevent electrical
shock and possible fatal injury.
The MBS-1018-1 Horizontal Band Saw is rated at
single phase, 230V power only . The band saw
comes with a plug designed for use on a circuit with
a
grounded outlet that looks like the one pictured in
Figure 9-1.
It is recommended that the MBS-1018-1 band saw
be connected to a dedicated 15-amp circuit with
circuit breaker or time-delay fuse marked “D”.
Local
codes take precedence over recommendations.
The MBS-1018-3 Horizontal Band Saw is rated at 3-
phase, 230/460V and is prewired for 230V. The
MBS-1018-3 is not provided with an electrical plug;
you may either attach a proper UL/CSA-listed plug,
or “hardwire” the machine directly to a service panel.
It is recommended that the MBS-1018-3 band saw
be connected to a dedicated 7-amp circuit with
circuit breaker or time-delay fuse marked “D”.
Local
codes take precedence over recommendations.