5
Overall (LxWxH)
810x300x390mm
Net weight
45 kg
Mains
230V ~1/N/PE 50Hz
Output power
0,55 kW (0,75HP) S1
Reference current
4.1 A
Extension cord (H07RN-F):
3x1,5²
Installation fuse protection
10A
4.2 Noise emission
Acoustic pressure level (EN 11202):
Idling
67,4 dB (A)
In operation
76,5 dB (A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Work lamp (JWL-1220VS only…..
fluorescent bulb not included)
150mm tool rest
250mm tool rest (JWL-1220VS only)
Spindle adapter 1”x8TPI / M33x3,5
75mm face plate
Safety goggles
Spur centre and tooling knockout
Operating tools
Assembly kit
Operating manual
Spare parts list.
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate in
closed rooms and must be placed
stable on a firm and levelled table
surface.
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
The JML-1014VSI is fully assembled.
JWL-1220VS:
Install the tool caddy using the two
pan head screws (Fig 1).
Fig 1
Install a max 11W, 230V flurescent
bulb into to the work lamp (Fig 2).
Fig 2
Warning:
Never use an incandescant bulb
(high risk of wooden dust and
cutting chips to chatch fire on a hot
light bulb).
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
10 A surge-proof fuse.
Only use power cords marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Dust collection
Use a suitable dust collection and
filtration system to avoid a high dust
concentrations in the air.
5.5 Starting operation
You can start the machine with the
green ON-button (A, Fig 3).
The lathe will begin turning and
driving the headstock spindle. The
lathe will reach full speed in about 1 to
3 seconds.
Fig 3
The red OFF-button stops the
machine.
Wait for the workpiece to come to a
complete stop.
The variable speeds of the lathe are
controlled by the speed knob (E) on
the control box as well as the position
of the belt on the pulleys.
Warning:
Always set the speed control knob to
its lowest setting before starting lathe.
Never start a workpiece at maximum
speed.
In case of machine overload the reset
button (C) will react.
-Turn off machine power
-Push the reset button
-Then re-start the lathe.
6. Machine operation
Successful wood turning does not
result from high speeds, but rather,
from the correct use of turning tools.
A perfect and sharp wood turner tool
is a precondition for professional
wood-turning.
