Jet JWBS14DXPRO, Инструкция по эксплуатации и каталог запасных частей

Страница: 9 / 28

9
Mounting the Trunnion Bracket to
the Band Saw
1. Attach trunnion support to saw body with two
M8 x 40 hex cap screws and two M8 lock
washers. See Figure 2.
2. Thread nut on to table stop bolt (Fig. 2) and
attach to trunnion support bracket as shown.
Once table is mounted to the trunnion bracket (see
section below) and the blade is mounted in the
saw (see section “Changing Blades”) you may
choose to fine tune the blade parallel to the miter
slot. Using a square positioned in the miter slot,
loosen screws shown in Figure 2 and lightly tap the
table into position so the blade is parallel with the
miter slot. Then gently tighten down the screws.
This adjustment will ensure square cuts when
using a miter gauge. This adjustment will NOT
correct drift of a blade when ripping with a rip
fence.
Mounting the Table to the
Bandsaw
1. To mount the table, remove pin and insert from
the table (Fig. 3).
2. Rotate the table so that the saw blade will slide
through the slot in the table. Then orient the
table so the screws will slide into the holes on
the trunnion support bracket. Attach lock knobs
to these screws (Fig. 3)
3. Replace pin and insert.
Figure 2
Figure 3