Jet JWBS14DXPRO, Инструкция по эксплуатации и каталог запасных частей

Страница: 12 / 28

Adjustments
Tilting the Table
Unplug the machine from the power
source before making any repair or adjustment!
Failure to comply may cause serious injury!
1. Loosen two lock knobs (Fig. 4).
2. Tilt table up to 45 degrees to the right or down 10
degrees to the left, using the scale mounted to the
trunnion.
3. Tighten two lock knobs (Fig.4).
Note: Table stop can be removed or further adjusted to
tilt table to the left.
Adjusting 90° Table Stop
Disconnect machine from the
power source.
1. Loosen lock knobs (Fig. 4) and tilt table left until it
rests against table stop.
2. Tighten Lock knobs
3. Use a square placed on the table and against the
blade (Fig. 5) to see if the table is 90 degrees to the
blade.
4. If an adjustment is necessary, loosen lock knobs,
tilt table to the right, and lock in place.
5. Loosen jam nut and turn table stop (Fig. 4) left or
right to raise or lower the stop. Tighten jam nut to
hold table stop in place.
6. Unlock table, tilt back onto table rest and confirm
table is 90 degrees with the blade.
7. If necessary, adjust scale pointer to zero.
Figure 4
Figure 5