Jet JRL-912, Инструкция по эксплуатации и каталог запасных частей

Страница: 13 / 28

13
7.0 Adjustments
7.1 Stand mobility
1. Push down pedal on swivel caster (Figure 7-1)
to move stand. Lift up pedal with foot to
disengage swivel caster. NOTE: The height of
levelers may need adjustment for proper
swivel caster engagement/disengagement.
Disengage swivel caster
before operating router; stand should be in
fixed position.
Figure 7-1
7.2 Miter gauge
The miter gauge (Figure 7-2) can be used for end-
routing a workpiece. Insert miter gauge bar into
end of T-slot and slide gauge onto table. Loosen
wing nuts to adjust fence. For angle cuts, loosen
handle and rotate body to desired angle on scale.
Tighten handle.
Figure 7-2
The fence must be set parallel to miter slot when
using miter gauge. This can be done quickly by
moving fence to equal dimension on left and right
scales if the initial fence alignment was done
properly (see
sect. 5.7 and Figure 5-9).
For precise work, verify setting of miter gauge
angle by placing an angle measuring device
against miter gauge fence and T-slot.
The narrow table T-slot will accommodate
additional routing accessories.
7.3 Router elevation
Insert pin wrench and turn to lock or unlock insert.
To raise or lower router, insert crank handle into
hole and turn. To secure router height, use crank
handle in “Lock” hole.
Figure 7-3
8.0 Operations
Before using this Router Lift,
thoroughly familiarize yourself with the safety
and operating instructions that accompanied
your router.
1. Disengage swivel caster before operating
router.
2. For safety, adjust sub-fences and router bit
guard as close to router bit as possible without
interfering with bit or workpiece movement.
3. Adjust ventilation in dust collection box by
rotating vent blades (see Figure 5-7).
4. Connect a dust collection system (not
provided) to the dust port, with a 4-in. dust
hose and clamp.
5. Power switch (Figure 8-1): Pull up paddle to
start router, push down to stop. To prevent
accidental or unauthorized use of router, pull
out safety key. Key must be reinserted to start
router.