Jet JRL-912, Инструкция по эксплуатации и каталог запасных частей

Страница: 11 / 28

11
Figure 5-9
5.8 Installing Router Lift
See Figure 5-10.
1. Insert ten flat head screws (#2, provided with
table) into holes in table recess – threaded
holes in cast iron table; pilot holes in MDF
table).
2. Place Router Lift into hole, and place a straight
edge across table and router plate. Continue
adjusting flat head screws until router plate sits
flush with table surface at all four edges.
3. Cast iron table: Install and tighten hex nuts
(#3) on each screw beneath recess (not
applicable to MDF table).
4. Insert two flat head screws through router
plate into table and tighten with 4mm hex
wrench.
Figure 5-10 (cast iron table shown)
5.9 Installing router (not provided)
The universal clamp collar will secure a router
without the need to match hole patterns on its
mounting plate. The Router Lift accepts
round body
routers only, with minimum 3-1/4” diameter to
maximum 4-1/4” diameter. Router must be
disconnected from power when installing.
1. Lower router lift with crank handle (see Figure
7-30) so that router spindle will not protrude
through insert when being installed.
2. Remove router lift and place upside down on a
table.
3. Slide router (not provided) as far as it will go
into router lift collar. If router body diameter is
too small, install one of the provided adaptors
into collar first, then install router. See Figure
5-11.
4. Position router so that power cord will be
toward right side of dust collection box.
5. Loosen two hex nuts (A, Figure 5-11) and
tighten screw (B, Figure 5-11) with 8mm hex
wrench. Retighten hex nuts to secure setting.
Make sure router is firmly
secured in clamping collar before
operating.
6. Replace Router Lift in table and secure with
the two flat head screws.
7. Remove cord clamp from right panel of Dust
Collection Box (see Figure 5-7). Feed router
cord through hole and insert plug into
receptacle on back of switch.
8. Reinstall cord clamp.
Figure 5-11