Jet JHBS916, Руководство пользователя

Страница: 10 / 16

10
www.jetgroupbrands.com
Vise Adjustment
To position the moveable vise jaw:
1. Turn vise handwheel (A – Fig.10) 1/2 turn
counter-clockwise.
2. Move rack block (B – Fig.10) to desired location
by sliding along the bed. Place the rack block
onto the rack.
3. Turn the handwheel to tighten the vise.
To adjust the vise for angle cutting:
1. Loosen bolts and move vise jaw (C – Fig.10) to
desired location.
2. Set the vise to desired angle, reinstall nuts and
tighten the nut and bolt assemblies.
3. Adjust the movable vise parallel to the fixed vise
by loosening bolt (D – Fig.10) adjusting
to parallel and tightening bolt.
Setting Up the Machine for Operation
1. Select the proper speed and blade for the type of
material you are going to cut.
2. Make sure blade tension is adjusted properly.
3. Lift the saw frame up and turn off the hydraulic
regulating micro switch.
4. Place the stock between the vise jaws, set the
stock for the desired width of cut and tighten
the vise.
5. Make sure the left blade guide bracket (A) is
adjusted as close as possible to the left vise
jaw (B) Fig.11.
6. Turn the hydraulic regulating micro switch (C)
Fig.11, counter-clockwise until the saw blade
begins to lower at the desired rate.
7. Proceed to cut through the workpiece, as
shown in Fig.11. The machine will shut off upon
completion of cut.
Fig. 11
A
C
Fig. 10
A
B
C
D