Jet JHBS916, Руководство пользователя

Страница: 9 / 16

9
www.jetgroupbrands.com
Automatic Shut-Off Adjustment
The motor should shut off immediately after the
blade has cut through the material and just before
the head comes to rest on the horizontal stop bolt.
If the machine continues to run after the workpiece
has been fully cut, locate and adjust the micro switch
mounting plate (part #45) downward. If the machine
shuts off before the workpiece has been completely
cut, move the micro switch mounting plate upward.
Thrust Roller Adjustment
1. Disconnect the machine from the
power source.
2. Loosen two hex socket cap screws (A-Fig.8).
3. Move guide seat (B - Fig.8) up or down until a
clearance of 0.003" to 0.005" between back of
blade and thrust roller is obtained.
4. Tighten two hex socket cap screws
(A - Fig.8).
5. Repeat for other blade guide assembly.
6. Connect machine to power source.
Guide Roller Adjustment
1. Disconnect the machine from the
power source.
2. Loosen blade guides (A – Fig.9) by loosening
screws (B). Slide blade guides away from blade.
3. Loosen locking screws (C) by using a
hex wrench.
4. Adjust the eccentric bushings with a combination
wrench until the ball bearings are snug to the
blade. Note: blade should travel freely up and
down between the ball bearings. Do not pinch
the blade.
5. Tighten locking screws (C).
6. Slide blade guides back into contact with blade
and tighten screws (B).
7. Connect machine to the power source.
Fig. 9
Fig. 7
Fig. 8
A
B
B
A
Locking
Screw
Guide
Seat
C
A
B
Blade
Thrust
Roller
Eccentric
Bushing
Inner Roller
(Blade Guide Roller)