5
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Stand assembly (Option)
(Article No.: 708438)
Mount the legs to the outside of the
supports, using 16 carriage bolts and
nuts (Fig 1)
Fig 1
Mounting the table
Remove the knobs (A, Fig 2), washers
(B) and the trunnion holders(C) on
both sides.
Fig 2
Lift the table (D) into position.
Reinstall the trunnion holders,
washers and knobs.
Mounting the dust port
Place the gasket (E, Fig 3) and mount
the dust port (F) to the sander with
four M6x16 hex cap bolts (G).
Fig 3
Mounting the sanding disc guard
Attach the sanding disc guard (O, Fig
4) with two screws (N).
Fig 4
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a 10
A surge-proof fuse.
Only use power cords marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Dust connection
Before initial operation, the machine
must be connected to a dust collector.
The suction should switch on
automatically when the belt sander is
switched on.
Flexible hoses must be of non-
flammable quality, and must be
connected to the dust collector ground
system.
Mounting canister filter (Option)
(Article No.: 708434)
The disc sander has a built in fan
designed to suck the saw dust away
from the sanding disc and exhaust
through the dust port.
Remove the dust port that came with
the sander.
Mount the plastic elbow (A, Fig 5) to
the sander using the same hardware
(B) from the dust port.
Connect the filter (C) to the elbow and
turn counter-clockwise so that it locks
in place.
Fig 5
Warning:
Static electricity will build up in the
filter during operation. The filter
ground must be attached to the
machine ground, and to the filter.
Failure to comply may result in
fire/loss of property, or personal
injury.
Attach the end of the grounding wire
to the screw (D).
Attach the grounding clip (E) to the
metal part of the filter.
This will prevent static electricity.
5.5 Starting operation
You can start the machine with the
green ON-button. The red OFF-button
on the main switch stops the machine.
After you have turned “OFF” the
sander you can press the brake (B,
Fig 5) to stop the sanding disc rapidly.
