5
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of
the hazards and risks involved only.
4.3 Contents of delivery
Machine stand
27mm bimetal sawblade
Adjustable material stop
Belt drive and cover
Hydraulic cylinder
Coolant facility
Assembly kit
Operating manual
Spare parts list
4.4 Machine description
Fig 1
A….Power indicator light
B….ON-button
C….OFF-button
D….Emergency stop button
E….Coolant switch
F….Feed control valve
G….Feed ON/OFF valve
Fig 2
H….Blade tension handwheel
I…..Quick adjust Vise
J.....Vise operating handwheel
K.....Material stop
L.....Adjustable Blade guides
M….Wheel cover
O….Chip tray
P….Coolant sight glass
5. Transport and start up
5.1 Transport and installation
Lift machine off the pallet to the
desired location.
Use lifting straps and place them as
shown in Fig 3.
Fig 3
Warning:
The machine weight is
285 kg (HBS-916W).
355 kg (HBS-1018W)
Assure the sufficient load capacity
and proper condition of your lifting
devices.
Never step underneath suspended
loads.
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
16A surge-proof fuse.
Only use power cords marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Starting operation
You can start the machine with the
green ON-button (B). The red OFF-
button (C) on the control box stops the
machine.
The coolant pump (E) can be switched
on and off independently.
An emergency stop button (D) is
located in the centre of the switch box.
Fig 4
Note:
The saw is equipped with an
automatic Shut-Off.
The saw should stop just after the cut
has been completed. The stop tip has
to be adjusted accordingly.
6. Machine operation
Support long workpieces with helping
roller stands.
Work only with a sharp and flawless
sawblade.
