Jet AFS-1000C, Инструкция по эксплуатации и каталог запасных частей

Страница: 9 / 24

9
Read and understand the
entire contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.
6.0 Setup
6.1 Unpacking and cleanup
Inspect the Air Filtration Unit and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Air Filtration Unit is
installed and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor.
6.2 Shipping contents
Carton contents
1 Air Filtration Unit
1 Remote Control
1 CR2032 Battery
1 Manual and Warranty Card
4 Eye Bolts
6.3 Battery installation
1. Remove the battery cover on the rear of the
remote control as shown in Fig. 6-1.
2. Install the supplied battery
(CR2032) with the “+”
side facing upward (Fig. 6-1).
3. Replace the battery cover.
Figure 6-1
6.4 Installation
6.4.1 Overhead (ceiling)
Overhead structure (often
ceilings) must be capable of supporting the
weight of the air filtration unit and absorbing any
vibrations arising from the unit. Appropriate
fasteners must be used to secure to the ceiling.
Failure to comply may cause serious injury.
Never mount to surfaces such as dry wall, false
ceiling grids, etc.
When overhead mounting such as a ceiling, make
sure chain and ceiling hooks are properly rated for
hanging this unit.
Refer to figure 6-2. After noting the direction of air
flow, use the hole location dimension to place the
anchors in the ceiling so that the chains hang as
straight as possible.
Clearance should be at least 7 feet from bottom of
unit to the floor.
Figure 6-2
This unit will work best if located away from corners
and heating/cooling vents.
6.4.2 Benchtop
When bench top mounting is used, make sure that
the surface is flat and level and does not allow the
AFS to move over the surface which could allow it
to fall.
Verify that the bench is stable and secure and will
not tip causing the AFS to fall.
In either installation:
•
Route the power cord so that it will NOT
become entangled in the machine in any
way.
•
Route the cord to the power supply in a way
that does NOT create a trip hazard.
Air Flow
20-
1/16”
13
”
22
-
3/8
”