Jet 708598K, Инструкция по эксплуатации и каталог запасных частей

Страница: 16 / 28

16
Belt Arm Orientation
Loosen the belt arm lock screw (see Figure 13) to
tilt the belt arm to vertical or horizontal position.
The belt arm can also be secured at any angle
between. Always tighten the screw before
operating.
Note: Belt tracking may require re-adjustment if
the belt assembly is moved from vertical to
horizontal or back again.
Limit Screw Adjustment
This set screw (Figure 22) limits the rotation of the
belt arm to vertical and horizontal positions, and
has been pre-set. If it should ever need re-
adjustment:
1. Loosen lock nut on the set screw with a 10mm
wrench.
2. With a 3mm hex key, turn set screw all the
way in until it bottoms out. Back screw out
three turns and re-tighten lock nut, while
holding screw in place.
Disc Table Adjustment
1. Disconnect machine from power source.
2. Place a square on the table and against the
disc. See Figure 23. Loosen both lock knobs,
move the table until the square sits flush to
both surfaces at 90°, and re-tighten both
knobs. Note: You may need to pivot the stop
block out of the way.
3. Place a combination square in the miter gauge
slot and check the distance from the slot to
face of the disc. See Figure 24. Slide the
square along the slot to the other side of the
disc and check the distance. The distances
should be equal to ensure that the miter gauge
travels parallel to the disc.
4. If table is not parallel, loosen the four screws
holding the table to the trunnions (B, Figure
25) with a 12mm wrench, and nudge the table
until parallel. Re-tighten screws.
Note: Always maintain a gap of approximately
1/16” between the table edge and the abrasive
disc.
Once the table is square and parallel to the disc,
verify the stops, as follows:
Adjust 90° Stop
5. Loosen lock nut on the 90° stop (Figure 23)
with a 10mm wrench. Turn the set screw down
(3mm hex key) to contact the table. Re-tighten
lock nut.
Figure 22
Figure 23
Figure 24