Jet 708598K, Инструкция по эксплуатации и каталог запасных частей

Страница: 12 / 28

12
Assembly
Tools required for assembly:
4mm Hex Key
6mm Hex Key (provided)
13mm open-end wrench
(2) 11/16” wrenches or sockets
Machine is heavy! Use caution
when lifting out of the shipping carton and
moving to a final location. Stand or bench must
be stable enough to support heavy weight.
1. Use a hoist with straps to remove the Sander
from the carton. Prevent straps from
contacting any levers or switches while lifting.
2. Carefully position the machine on a workbench
or one of the optional JET stands. (Consult the
assembly instructions that accompanied the
stand.)
3. Bolt the unit firmly to secure it in position.
Figure 11 shows it being bolted to the optional
closed stand. Use the four M10x80 hex cap
screws, with M10 lock washers, flat washers
and hex nuts. Tighten hex nut while holding
the screw head stationary, using two 11/16”
wrenches. Remove lifting straps.
4. Exposed metal surfaces have been factory-
coated with a protectant. Remove this using a
soft cloth and a solvent or cleaner/ degreaser.
(Note: Keep solvents away from painted
surfaces and plastic parts, and do not use an
abrasive pad, as it may scratch the polished
metal surfaces.)
Machine should be dis-
connected from power during all assembly
procedures.
Disc Table
1. Remove the left and right trunnion brackets (A,
Figure12) from the trunnion holder (B).
2. Make sure the stop block (shown in Figure 23)
is flipped out of the way.
3. Place the disc table on top of the trunnion
assemblies and position each trunnion bracket
(A) so that it slips onto the threaded stud and
two pins of the trunnion holder (B), while
engaging the lip of the table trunnion (C).
Note: The trunnion brackets are not identical;
make sure the bracket with the raised indicator
line is installed on the left side of the table.
4. Install a lock knob (D) on each threaded stud
and tighten to hold the table in position.
Figure 11
(closed stand optional)
Figure 12