Jet 708598K, Инструкция по эксплуатации и каталог запасных частей

Страница: 15 / 28

15
Adjustments
Tools required for adjustments:
3mm hex key
6mm hex key (provided)
10mm wrench
13mm wrench
Combination and/or machinist’s square
Cross-point Screwdriver
Belt Table Adjustment
1. Disconnect machine from the power source.
2. Place a square on the table and up against the
platen or abrasive belt, as shown in Figure 19.
3. Loosen the table lock handle and move the
table until the square sits flush to both
surfaces at 90°. Tighten the lock handle.
4. Place a combination square in the miter gauge
slot and check the distance from the slot to the
face of the platen. See Figure 20. Slide the
square along the slot to the other side of the
platen and check the distance. The distances
should be equal to ensure that the miter gauge
travels parallel to the belt.
5. If the table is not parallel, loosen the screws
below the table (A, Figure 21) with a 13mm
wrench, and nudge the table until parallel. Re-
tighten screws.
Note: Always maintain a gap of approximately
1/16” between the table edge and the abrasive
belt.
Once the table is square and parallel to the belt,
verify the stops, as follows:
Adjust 90° Stop
6. With the table locked at 90°, loosen the hex
nut on the 90° stop, and adjust the set screw
to seat against the stop block. See Figure 19.
Re-tighten hex nut to secure the setting.
7. If angle indicator adjustment is necessary,
loosen the screw and shift the pointer to zero,
and re-tighten the screw.
Adjust 45° Stop
8. Flip the stop block out of the way, and tilt the
table down to 45°. Verify the setting of the 45°
angle stop (Figure 19). Use the same
procedure as above but with a 45° measuring
device on the table. Correct the stop as
needed.
Figure 19
Figure 20
Figure 21