Jet Central Rabbit, Руководство по эксплуатации и обслуживанию

Страница: 40 / 44

January, 2009 39
11 Troubleshooting
PROBLEM CAUSE SOLUTION
When raising the trim of
the radio, the LED is not
illuminated I.C.S. in stop mode after running.
Bad adjustment of radio
transmitter.
Supply Failure.
Switch off and on the I.C.S.
(RX) again.
Program the parameters of
the radio.
Verify battery power, check
connectors.
After cycling the throttle
“Glow Bad” message
appears Blown glow plug or disconnected. Check glow plug and battery.
After cycling throttle
nothing happens and
later the “Start Bad”
message appears. Start motor bad/disconnected. Check starter.
After cycling throttle the
rotor turns but later the
“Start Bad” message
appears. Starter power to low.
RPM sensor failure.
Check starter battery.
Check starter to run freely.
Check RPM sensor
connections.
The RPM are cycling but
gas doesn’t ignite. Gas empty or gas solenoid valve
disconnected or bad.
Glow plug brightness to low.
Too much or not much gas.
Check the Gas supply.
Check/adjust glow plug
brightness and filament is
pulled out.
Check restrictor clogged or
missing.
When the gas is ignited
the “Start Bad” Message
appears. The starter failed to have the
minimum RPM to continue the
sequence. Check the starter Battery.
Check the starter.
When the start gas is
ignited the
I.C.S. does
not begin to pump fuel
and “Time Out” message
appears
The Temperature isn't hot enough
to start the fuel ramp.
There is not much gas.
Gas does not ignite.
Check the temperature probe
that it’s inserted in the tail
pipe 1/16”.
Check restrictor clogged or
missing.
Check glow plug.
When the fuel ramp
starts and the “Weak
Gas” message appears The fuel is not reaching the
engine. Check fuel lines.
Check manual valve is open.
Prime an try again