JessEm Tool Mite R Slide, Руководство пользователя

Страница: 8 / 17

25. Check for square and repeat if necessary.
When the fence is square, tighten all cap screws
again. To tip the fence back - make the same
adjustments but adjust the right side set screw
instead of the left. Adjust the set screw on the left
side bearing tube bracket to tilt forward, adjust
the right side to tilt back.
FIG
.
21
22. Check to see if the miter fence is square
to the table top (Fig. 21) If not you will need
to make the following adjustment.
23. Loosen the two cap screws on the
upright miter gauge bracket (Fig. 22). Now
loosen the cap screws on both bearing tube
brackets (Fig. 23).
FIG
.
22
FIG. 23
FIG. 24
24.To tip the fence forward turn the far left set
screw until it bottoms out. Then loosen the left
cap screw a ¼ turn. Then turn the set screw
clockwise again until it bottoms out.
SQUARING THE FENCE TO THE TABLE TOP
21. The top of the bearing tube bracket on
the shaft has tapped holes with a set screw in
the outer left and outer right holes. These are
used to square the miter fence to the table
surface (Fig. 20).
FIG
.
20