Jersey Jack Pinball Pirates of the Caribbean, Руководство по эксплуатации

Страница: 22 / 359

Game Assembly & Setup
A-10
G
M
M More Sensitive
Less Sensitive
Figure A15. Assembled plumb bob tilt mechanism.
16)
Locate the plumb bob weight and nylon wing nut in the loose parts. Locate the
plumb bob tilt hanger wire and contact brackets, mounted on the inside, left sidewall of
the lower cabinet. Slide the weight onto the straight end of the hanger wire and thread
the wing nut onto the shaft underneath it (figure A15). Raising the weight higher up the
hanger wire (by tightening the wing nut underneath it) makes the tilt mechanism more
sensitive; lowering the weight makes it less sensitive. Carefully lower the playfield and
slide it straight back into the cabinet, ensuring that the two hanger brackets rest in the
slots in the lockdown bar receiver channel. Carefully reinstall the playfield glass and lock-
down bar by reversing the steps in
10)
above.
17)
Locate the power cord in the loose parts. Remove the line cord cover plate from the
rear of the lower cabinet (figure A16). Plug the female end of the power cord into the
exposed receptacle, inside of the back of the machine. Replace the line cord cover plate
and plug the other end of the power cord into a grounded wall outlet. DO NOT CUT THE
GROUND LUG OFF OF THE POWER CORD!
18)
Power up the game (the on/off switch is located under the cabinet, just behind the
right front leg; it rocks in one direction to turn the game on and in the reverse direction
to turn it off) and test it for proper operation. Adjust game settings as appropriate (see
Game Menu System, Section B). Your game is ready to play!
Figure A16. Line cord cover location.