Assembly
10
Always secure the child by using all of the positioning straps and safety straps provided. Velcro
should overlap by at least 3 inches
(7.5 cm)
on all straps before you begin to make any other
adjustments. Ensure the safety strap and positioning strap are adjusted for each child and for
changes of clothing.
Te
chnical User
GB
FOR FREE ADVICE ON THE USE OF THIS PRODUCT, PLEASE CONTACT OUR SALES SUPPORT TEAM
Jenx Limited, Wardsend Road, Sheffield, S6 1RQ. Tel: +44 (0)114 285 3376. Fax: +44 (0)114 285 3528. [email protected] www.jenx.com
Do not use
this product if you suspect it is faulty or broken.
Contact Jenx Limited immediately for advice. +44 (0) 114 285 3376
Never Leave your child unattended while using this product
Fitting the Tray to your Rex Stander
The tray is fixed to the stander in two places. First loosen the bolts behind the chest support (fig 1) and
slide the tray over the bolts keeping the washers on the outside of the tray. Slide the tray right down as far
as it will go and tighten the wing nuts securely. Next, slide the channels at the side of the tray over the
bolts (fig 2) and push the tray to the desired angle and tighten.
(The Cat and Penguin will arrive with the tray already fitted).
With the tray removed, your
stander can be used right up to a
table or play tray. (fig 3) When
removing the tray, always keep
the wing nuts tightly in place on
the stander for future use.
See page 19 for tray adjustments.
Fig 1
Fig 2
Fig 3