INSTALLATION INSTRUCTIONS
Step # 7
Locating Margue Rocket Fin and mounting location
The back access door for the main cabinet can be removed by
unbloting the 4 lower machine screws from the dorr. These 4 screws
are shown with the green arrows to the picture to the right. Once
those 4 machine screws are removed you can loosen the upper two
machine screws (Marked with red arrows), and then lift the back
access dorr up off the two top screws and the door can be removed.
Step # 8
Step # 9
Removing The back door
Check Box When This Step is Complete
The upper Margue fin for the rocket is installed using 3, 4mm machine
screws. To install you need to use a 2.5mm Hex headed allen key. Be
sure to not to damage the LED light strip that runs under the newley
installed fin. Also the LED lights need to be pointed toward the fin to
light the fin up like the rest. If the LED are installed up side down the
Fin will not iluminate.
Locate the Upper Marque fin for the Rocket in the spare parts box.
This Fin is attached to the Marque before you mount the Header onto
the main cabinet for ease of installation. Even thought it is
recommended to install first this step can be accomplished after the
marque is installed. The bottom picture to the right shows the
location to mount the Fin.
Mounting the Marque Rocket fin
Check Box When This Step is Complete
Jennison Entertainment Technologies
Rocket Wheel Service Manual
Page 14
