Jenn-Air JGC3115GS, Руководство по установке

Страница: 8 / 20

8
Make Gas Connection
To Assemble Pressure Regulator:
1. Install the pressure regulator with the arrow pointing up
toward the bottom of the burner box and in a position
where you can reach the regulator.
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause
a gas leak. Do not allow the regulator to turn on the pipe
when tightening fittings.
2. Connect the flexible stainless steel connector to the pressure
regulator using a 1/2" (1.3 cm) male pipe thread adapter.
A combination of pipe fittings must be used to connect the
cooktop to the existing gas line. Shown in the following
illustration is a typical connection. Your connection may
be different, according to the supply line type, size, and
location.
NOTE: When installing the cooktop above a built-in oven,
install a 90º elbow - 1/2" (1.3 cm) female to 1/2" (1.3 cm)
male between the cooktop manifold pipe and the pressure
regulator. The regulator must be set with the arrow pointing
toward the cooktop. Apply pipe joint compound for use with
Propane gas to the end of the cooktop manifold pipe and the
male end of the 90° elbow.
Use only pipe-joint compound made for use with Natural and
Propane gas.
Do not use TEFLON
®† tape. You will need to determine the
fittings required depending on your installation.
Typical flexible connection
1. Apply pipe-joint compound made for use with Propane gas
to the larger thread ends of the flexible connector adapters
(see B and F in the following illustration).
2. Attach one adapter to the gas pressure regulator and
the other adapter to the gas shut-off valve. Tighten both
adapters.
3. Use a 15/16" (2.4 cm) combination wrench and channel lock
pliers to attach the flexible connector to the adapters. Check
that connector is not kinked.
No appliance/obstructions
below cooktop
Suggested installation to
avoid interference below
cooktop
A
B
C
D
E
F
G
H
I
A
B
C
D
E
F
I
G
H
A. Manifold entrance
B. Gas pressure regulator
C. Use pipe-joint compound.
D. Adapter (must have 1/2"
[1.3 cm] male pipe thread)
E. Flexible connector
F. Adapter
G. Use pipe-joint compound.
H. Manual gas shut-off valve
I. 1/2" (1.3 cm) or 3/4" (1.9 cm)
gas pipe
A. Manifold entrance
B. Elbow (1/2" [1.3 cm] female to
1/2" [1.3 cm] male)
C. Flexible connector (pass
through wall between cabinets)
D. Adapter (must have 1/2"
[1.3 cm] male pipe thread)
E. Use pipe-joint compound.
F. Appliance pressure regulator
(supplied)
G. 1/2" (1.3 cm) or 3/4" (1.9 cm)
gas pipe
H. Manual gas shut-off valve
I. 1/2" (1.3 cm) or 3/4" (1.9 cm)
gas pipe
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to propane, have a qualified person make
sure gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
A
C
D
B
A. Gas pressure regulator
B. Up arrow - regulator must be installed
with arrow pointing up at cooktop bottom.
C. Adapter (must have 1/2" [1.3 cm] male pipe thread)
D. UL Listed or CSA Approved flexible
stainless steel gas supply line
† ® TEFLON is a registered trademark of Chemours.