Jenn-Air JDRP548W, Руководство по установке

Страница: 15 / 40

15
A
B C
D
E
F G
H
A. Gas pressure regulator
B. Use pipe-joint compound.
C. Adapter (must have ½" male
pipe thread)
D. Flexible connector
E. Manual gas shut-off valve
F. ½" or ¾" gas pipe
G. Use pipe-joint compound.
H. Adapter
A. Closed valve
B. Open valve
A
B
3. Attach one adapter to the gas pressure regulator and
the other adapter to the gas shut-off valve. Tighten both
adapters, being certain not to move or turn the gas
pressure regulator.
4. Use a
ZB\zn
" combination wrench and an adjustable wrench
to attach the flexible gas supply to the adapters. Check that
connector is not kinked.
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making the
connections too tight may crack the regulator and cause a gas
leak. Do not allow the regulator to turn or move when tightening
fittings.
Complete Connection
1. Open the manual shut-off valve in the gas supply line.
The valve is open when the handle is parallel to the
gas pipe.
2. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles
appear, a leak is indicated. Correct any leak found.
3. Remove cooktop burner caps, burner bases, and grates
from parts package. Place burner bases on cooktop and
burner caps on burner bases. Place grates over burners
and caps.
4. Check that the range is plugged into the appropriate
grounded outlet. (See the “Electrical Requirements” section.)
5. Turn on power supply. For further information, please refer
to the user instructions located in the Use and Care Guide.
Verify Anti-Tip Bracket Location
1. Using a
B\zn
" socket or wrench, turn all 4 leveling rods one
full turn to raise the range and provide enough clearance
for the rear leveling leg to slide into the anti-tip bracket.
2. Move range into its final location, making sure rear leveling
leg slides into anti-tip bracket.
3. Use a flashlight to look underneath the bottom of the range
and visually check that the rear range foot is inserted into
the slot of the anti-tip bracket.
Level Range
NOTE: Range must be level for satisfactory baking
performance.
1. Place rack in oven.
2. Place level on rack and check levelness of the range –
first side to side, then front to back.
3. If range is not level, adjust the leveling rods. Turn leveling
rods located behind the kick plate to level range and to
raise or lower range to the desired countertop height.
NOTE: All roller feet must be off the floor upon final installation.
A
A
B
B
A. Rear leveling rod
B. Front and brass leveling rod
Install Griddle
(on griddle models)
The griddle is factory installed.
1. Place drip tray in the well at the front of the griddle.
Slide tray toward the back until it stops.
2. Clean griddle before using. Refer to the Use and
Care Guide.
A. Griddle drip tray
B. Griddle
A
B