12
DISHWASHER FEEDBACK SECTION
Canceling A Cycle
1.
Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2.
Press CANCEL/DRAIN. The Cancel/Drain indicator will glow.
3.
Close the door and the dishwasher starts a drain cycle (if water
remains in bottom of dishwasher). Let the dishwasher drain
completely. The Cancel/Drain indicator turns off after 2
minutes.
Changing A Cycle After Dishwasher Is Started
1.
You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure.
2.
Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3.
Check that detergent dispenser cover is still closed. If cover is
open, you will need to refill the detergent dispenser before
restarting your new cycle.
4.
Press CANCEL/DRAIN twice to reset the control.
5.
Select new cycles and options.
6.
Press START/RESUME.
Adding A Dish After Dishwasher Is Started
1.
Check if Add a Dish indicator is lit. (Available on some models.
Otherwise, proceed to Step 2.)
2.
Open the door slightly to stop the cycle. Wait for the spraying
action to stop, and then open the door completely.
3.
Check whether the detergent dispenser cover is still closed. If
it is open, the wash cycle has already started and adding a
dish is not recommended.
4.
If detergent has not yet been used (detergent dispenser cover
is closed), you may add a dish.
5.
Press START/RESUME.
DISHWASHER FEATURES
Your Jenn-Air
®
dishwasher may have some or all of these features.
Silverware Basket
Use the slots in the covers to keep your
silverware separated for optimum
wash. There are specially designed
slots (small round holes) for chopsticks.
Mix silverware types to keep them
separated. Load knives down, forks up,
and alternate spoons, for best cleaning
results.
NOTE:
If your silverware does not fit into the designated slots, lift
and slide the covers off of the silverware basket.
Cup and Stemware Holder (on some models)
Fold down the extra shelf on the left-hand or right-hand side of the
top rack to hold additional cups, stemware or long items such as
utensils and spatulas.
NOTE:
Remove the culinary tool basket(s) when washing tall
stemware or other tall items in the top rack.
CONTROLS AND CYCLE STATUS
CONTROL
PURPOSE
COMMENTS
To follow the progress of the
dishwasher cycle.
Clean indicator glows when a cycle is finished.
If you selected the Sani Rinse option, the Sanitized indicator glows when
the cycle is finished. If your dishwasher did not properly sanitize your
dishes, the indicator flashes at the end of the cycle. This can happen if the
cycle is interrupted, or the water could not be heated to the required
temperature.
If Add Dish is glowing, you may add a dish even though the cycle has
started. After adding a dish, press START/RESUME before closing the
door.
For Water Softener models, the Add Salt indicator will glow when it is time
to add salt to the Salt Container. Refer to the Water Softener System User
Instructions for instructions for filling the salt container.
The Clean and Sanitized indicators turn off when you open and close the
door, or press CANCEL.
The Front Indicator Light or
Single Exterior Light (A)
shows progress of your
dishwasher cycle by color
(on some models).
The light will be blue if the dishwasher is washing or rinsing. The light will
be red when the dishwasher is drying. The light will be white to indicate
that the cycle is complete. If the Front Indicator Light is blinking, see
“Troubleshooting” section.
A
