86
GETTING TO KNOW YOUR VEHICLE
5. Using the provided #40 Torx head driver
and ratchet, tighten the Torx screws by
turning them clockwise. Secure them until
they are snug (refer to the table below for
recommended torque specifications), being
careful not to cross-thread the screws or
overtighten. Repeat on the opposite side.
Step Five
6. While pulling the release lever on the top of
the rail rearward, place the side link into the
guide track on the top of the rail then
release the lever.
Step Six
7. Unsnap and remove the black boot cover.
This cover should be discarded. It was
intended as a protective cover for shipping
only.
NOTE:
Be sure the wire harness in the left rear corner
is not tangled in the soft top bows before you lift
the top.
1 — Lock Position
2 — Torx Head Screw
3 — Torx Head Screw
Torque Speci
-
fication For
Torx Screws
Maximum
Minimum
119.5 in-lbs
150.5 in-lbs
106.2 in-lbs
13.5 N·m
17.0 N·m
12.0 N·m
CAUTION!
Do not overtighten the screws. You can strip
the screws if they are overtightened.
21_JL_OM_EN_USC_t.book Page 86
Содержание WRANGLER 2021
