Key
1 – Housing pipe
2 – Ball head tow bar
3 – Locking balls
4 – Release ball
5 – Release lever
6 – Knob
7 – Cap
8 – Key
9 – Red marking (knob)
10 – Green marking (knob)
11 – Green marking (tow bar)
12 – Symbol (control release)
13 – Closing cap
14 – Engagement pin
15 – Absence of slots between 2 and 6
16 – Slot of 5 mm approx.
A
: locked position (driving)
B
: released position (removed)
Installing the ball head tow
bar
Remove the plug from the mounting
pipe.
The ball head tow bar is usually in the
released position when taken out from
the luggage compartment. This can
be observed by the knob spaced from
the tow bar, corresponding to a slot
of approximately 5 mm (see fig. 101)
and by the red mark on the knob
directed to the green mark on the tow
bar. The tow bar can be installed only
when in these conditions.
If the locking mechanism of the tow bar
is disengaged before the installation,
or at any other time, and is in the
locked position, it must be pre-loaded.
The locked position can be identified
by the green mark of the knob
coinciding with the green mark of the
tow bar and by the knob in the stop
position on the tow bar, namely without
slot (see figure).
The locking mechanism is pre-loaded
as follows:
❒
with key inserted and lock open,
extract the knob following the direction
of arrow A fig. 101;
❒
then follow the direction of arrow B,
until it stops.
The release ball is pre-loaded and the
locking mechanism remains in the
pre-loading position even when the
knob is released.
The release lever is engaged and the
locking mechanism remains in the
pre-loading position even when the
knob is released.
The tow bar must be inserted in the
housing pipe with the coupling pin for
the installation. Insert from the bottom
and push upwards: the mechanism
locks automatically.
IMPORTANT To prevent injury to limbs,
keep hands away from the knob when
locking.
Close the lock and always remove the
key. The key cannot be removed when
the lock is released. Then fit the
protection cap on the lock.
Removing the tow bar
Proceed as follows:
❒
remove the protection cap from the
lock and press it on the key grip. Open
the lock with the key;
❒
grip the tow bar firmly, remove the
knob following the direction of arrow A
fig. 101, then rotate in the direction
of arrow B until it stops, in order to
release it in unlocked position. Then
remove the tow bar from the housing
pipe. The knob can then be released (it
will automatically stop in released
position);
❒
arrange the tow bar in the luggage
compartment so that it cannot be
dirtied and/or damaged by other
transported objects;
❒
finally, insert the dedicated plug in the
mounting pipe.
Important
Apply the plate in a highly visible point
of the vehicle, near the mounting pipe
or inside the luggage compartment.
119
Содержание Renegade
